Z2 750 crank (Bossie the Kaw)

They're working good. I guess they reset after a while. How long I'll find out.
Steve

The forks looked naked without it. :dry:
Steve

New bolts.
Steve

I'm liking them.
Steve

Not going to be just valve lapping this time. :dry:
Steve

Might be able to get the valves out.
Steve

Do you have a multi angle seat cutter set?
If the seats are not beat up, keeping the margins in mind, you might be able to lap in the other valves with very little trouble.
If they are a little wide, maybe using spring shims will increase pressure seal enough anyhow.
I say that because it’s not a race engine and your not constantly flogging it.

My friend Jeff has a set. I may wind up replacing the guides as well.
"I say that because it’s not a race engine and your not constantly flogging it."
:lol: You've seen my clips, when don't I flog it? :woohoo:
I just wish I could afford to send it to Larry or someone like him to perform their magic.
I'd like to get back into it to install crank studs and have the crank welded but that's not in the cards.
A 1105 kit would be nice too.:whistle:
Steve

Finally got to the harness. Pardon my potty mouth. :blush:
Steve

Almost there.
Steve

Still more bugs to work out.
Steve

Found it.
Steve