TOPIC:

ooops maybe you meant the "fat" side, oh crap I have now exposed a mistake that could have remained hidden therby making myself look silly!!

Ok the fat side is an experiment of sorts. I am thinking about putting one of those really short GSXR steering stabilizers on, there is a 1/4-20 tapped hole on the side.

He he I just don't quite have that one figured out yet.

Here's what I did on my 900. You'll probably have to weld a tab on your triple tree.



Later, Doug

tk11b40 wrote:

ooops maybe you meant the "fat" side, oh crap I have now exposed a mistake that could have remained hidden therby making myself look silly!!

Ok the fat side is an experiment of sorts. I am thinking about putting one of those really short GSXR steering stabilizers on, there is a 1/4-20 tapped hole on the side.

He he I just don't quite have that one figured out yet.

Yes the fat side. I hope u can figure that 1 out too. The stabilizer will be a nice touch.
I am glad i used rattle can paint on my bike for this very reason. it's to hard to get everything perfect the first go round.
I will be making some of these mods myself before i do the final paint job. Is there any tips on witch stabilizer to buy? Thanks for sharing your ideas. You too Doug.

I'm still brainstorming the stabilizer.

I really like the way the photo submitted looks.....still thinkin....

Wow Tex, this things looking good. Will be nice to see it in person. Are you sure you can't bring it the WSB?

Stoppee....

Bring the scooter to WSB!! you know the "elite"!!

Oh wait mispelled "scooter"

"SCOUTER"???

Could be interesting...could see if we could put it on display at the Honda tent with the other custom bikes . Maybe able to convince them that it shows the abuse it has taken and keep running.

Ahh yes..

Next to the latest and grreatest CBR 1000rr, we have the elite, fastest scooter in the northwest.

Well my good buddie Ed the toolmaker let me use his lathe today, I machined up a slick set of bushings for the CR rear brake caliper (carrier), centering it on the axle and the diameter of the rear rotor. Two bushings that sandwich the carrier, and hold the rear wheel in the proper alignment to the countersprocket, and centered on the steering head.

Camera batteries are dead, soon as it's charged I'll post a photo.

If you are reading this, and have a project you have not posted, I encourage you to post it. I find myself thinking "hey it's been a week since I posted any new work". So you get busy on something. Kinda motovates you on the timeline.

Allright!!!

Lots of thinking and cyperhin went into the front and rear wheel alignment. Finally completed.

The CR 450 Caliper comes with a carrier, which has a giant hole in it for the dirt bike axle. So bushings are in order. I needed 1.330" spacing to rear wheel from swingarm and had to get the caliper centered on the rotor.

Solution: a two piece flange/ bushing that holds the caliper in the center of the rotor, and center of the axle.

Ahhhhhh let the machining begin!! So nice to make chips again.


Rather than bore you with yadda yadda technical writn jargon, I tried to graphicalize/ duct tape this here sicheeasion.

Here's a little more clarifacation on this here situation:

The total gyration of clarification, thats a homonagization of Old Kz, New ZRX, and New dirt bike!!!

Super light weight rear brake....

That there is some dedication to the motovation!!

Nowww ....Whadd I doo with that there duct tape anyhow??