Borrow Piston Ring Compressor? (kz1000)

hey friends! hoping to borrow a ring compressor for a kz1000 (72 or 73mm i believe, i can confirm if you have one about there) sometime later this month, or in early june. i'm still cleaning the cylinder cover and valves so i'm not in a rush , just wanted to check before i buy one like i did for the valve compressor haha.
i'm happy to provide a reasonable, refundable deposit for the tool and pay for shipping to and from if you are so kind to lend it to me.
happy to chat on the phone if you'd prefer additional vetting, i promise i'm just trying to get a nice old bike up and going again!

much appreciation,
sean

Location might be helpful. Maybe someone nearby has one.

M_a_t_t wrote: Location might be helpful. Maybe someone nearby has one.

fair, sorry. i'm in boston and would be willing to travel a lil bit to get it, 100 miles id say

I use hose clamps.
Steve

SWest wrote: I use hose clamps.
Steve

Same here . I connect 2 hose clamps toreather . Makes it easier to get them out after .Having a buddy help hold the cylinder helps too .

Cut a section from a plastic fizzy drink bottle and use cable ties around it. (not sure what you call cable ties over the pond)

Ive messed around with ring compressors a few times and have found its easiest to just do it by hand. (if the bores are chamfered at the bottom) Put 2&3 at TDC, compress the rings with your fingertips, work back and forth from 2 to 3 until they slide in, then do 1 & 4. a small screw driver can help to poke the ring in but be careful. It can be done in about 10 minutes.

DoctoRot wrote: Ive messed around with ring compressors a few times and have found its easiest to just do it by hand. (if the bores are chamfered at the bottom) Put 2&3 at TDC, compress the rings with your fingertips, work back and forth from 2 to 3 until they slide in, then do 1 & 4. a small screw driver can help to poke the ring in but be careful. It can be done in about 10 minutes.

Jay from APE recommended this and it was easy as pie...... the hose clamps sound good too but by hand worked great for me.

thank you for the great advice everyone! i've got a few friends who would be willing to help me try these out in good order. good to know that it can be done by hand, carefully

KZB2 650 wrote:

DoctoRot wrote: Ive messed around with ring compressors a few times and have found its easiest to just do it by hand. (if the bores are chamfered at the bottom) Put 2&3 at TDC, compress the rings with your fingertips, work back and forth from 2 to 3 until they slide in, then do 1 & 4. a small screw driver can help to poke the ring in but be careful. It can be done in about 10 minutes.

Jay from APE recommended this and it was easy as pie...... the hose clamps sound good too but by hand worked great for me.

Just use large amounts of oil to lube the rings

Dave

I have a factory ring compressor for the KZ1000 70mm bore. I did not think it worked easily and reverted to pushing the rings in with my fingernails. I assembled new rings and bore dry because back in the day race motors went together that way because there was no break in period.