Cam motion Z1/KZ cam shaft specs

here is a list of cam motion cams for z1's/kz/gpz's for reference.
it's nice to be able to see specs when looking for cams.

What's the price of drop in cams.
Steve

:blink: I don't think cam motion makes any motorcycle cams for z1/kz's any longer . ......... :blink: I posted the cam specs off of an old list I had so some one looking at used cams could have an idea at what they are thinking of getting or comparing to other cam shaft brands..... :S :pinch:

I think all KZ cam's will be hard welded and reground.
on your core's.
Webcam cam's for my GPz750 run about $450.00 a pair.

Hello the chart is really useful, one question where does it refers to the base circle? is 110? were it says center to lobe.

wrote:

Hello the chart is really useful, one question where does it refers to the base circle? is 110? were it says center to lobe.

 

Just for reference I have a Z9 in my drag bike, it has a 1.040" BC. Most lower lift cams have a bigger BC - 1.070" to 1.110". A lot of the higher lift cams (+.500") will have a BC of 1.000" and sometimes less.

All I see on that chart is timing specs for a 110LC - This is to check a baseline setup and has nothing to do with the BC.

Here is a list of Cam Motion grinds for 900/1000/1100 that gives the Base Circle :

Z1 - .400 Lift, 1.110" BC - Duration 2xx'

Z2 - .385 Lift, 1.110" BC - Duration 258'    

Z3 - .345 Lift, 1.090" BC - Duration 241' turbo cam
    
Z4 - .420 Lift, 1.110" BC - Duration 269'    

Z5 - .429 Lift, 1.060" BC - Duration 252'     

Z7 - .429 Lift, 1.060" BC - Duration 272'     

Z8 - .455 Lift, 1.050" BC - Duration 271'    

Z9 - .465 Lift, 1.040" BC - Duration 278'        
    
Z10 - .485 Lift, 1.000" BC - Duration 272'     
    
Z11 - .485 Lift, 1.000" BC - Duration 279'     

Z12 - .485 Lift, 1.000" BC - Duration 260'     

Z13 - .520 Lift,1.000" BC
    
Z14 - .507 Lift, 1.000" BC         

Z16 - .490 Lift, 1.000" BC     

Z17 - .485 Lift, 1.000" BC     
      
Z18 - .485 Lift, 1.040" BC    

Not sure where I grabbed this from but this is just for "reference" - All new or used cams must be measured to make sure they will work in your cylinder head.
 

Thanks