Krusty_47 wrote:I'm sending mine to him Friday. I'm sure it will look great. Now I need to figure out where to send the rest of my case pieces to get cleaned and or bead blasted.
If it's a non painted motor...
Strip the cases down completey & pull the studs, I can blast them, the block, the trans cover, oil pan, valve cover & head for $250.
When you get it back everything will be totally clean & ready for final assembly. Measure your stud heights before you pull them so you know what to set them to. I would just bail on the stock ones and put Jay's HD studs in the cases with his tool steel head nuts. Good stuff!
Painted motors take a lot more blasting time so the cost would go up on something like that if the goal was to take it to bare aluminum finish.
Larry C
