KZ400 fuel tank cap identification

Thank you very much!! If I end up finding something similar I will post a link here so others can find a possible replacement too

The distance between the seal and the top of the locking tabs might also be important.

By Nerdy: Right, so I was able to find the key *and* the calipers to take some measurements, so here we go.

overall diameter = 71mm

the black O-ring and the metal bit under it = 55mm

the round piece that goes into the tank - the outcropping at the 12:00 position = 34.5mm (C)

the round piece that goes into the tank + the outcropping = 38mm (D)

the two locking pieces when they're out = 41.5mm (E)

the central piece stamped 'Made in Japan' = 26mm (F) ...

Thanks for the measurements. Does this pic look right?

martin_csr wrote: Thanks for the measurements. Does this pic look right?

It certainly does - thank you! You beat me to it.

TexasKZ wrote: The distance between the seal and the top of the locking tabs might also be important.

That's a good point. I will grab that measurement when I have a chance.

Nerdy wrote:

TexasKZ wrote: The distance between the seal and the top of the locking tabs might also be important.

That's a good point. I will grab that measurement when I have a chance.

Hey Nerdy, just checking in to see if you've had an opportunity to measure the distance between seal and locking tabs? Thank you