Overflow

Pattenrd
Topic Author
Offline
User

01 May 2022 16:09 #866497 by Pattenrd

Overflow was created by Pattenrd

Purchased and installed air corrector on vm 26 carbs on early 78 KZ1000b benchnched them with .028 wire put back on motor turned gas on gas pours out overflow what would cause that floats seem fine float bowls have numbers 1&3on inside does that mean anything any help would be appreciated thanks

Please Log in or Create an account to join the conversation.

Nessism
Offline
Sustaining Member

01 May 2022 16:14 #866499 by Nessism

Replied by Nessism on topic Overflow

Float valves are not sealing.

Ed
Carb O-ring Kits : www.kzrider.com/forum/3-carburetor/61807...-o-ring-kits?start=0

www.kzrider.com/forum/faq-wiki/618026-new-owner-things-to-know

1981 KZ750E2
www.kzrider.com/forum/11-projects/604901...z750e-project-thread

Please Log in or Create an account to join the conversation.

Nessism
Offline
Sustaining Member

01 May 2022 16:14 - 01 May 2022 16:15 #866500 by Nessism

Replied by Nessism on topic Overflow

Float valves are not sealing.

Edit: I posted once, but this message showed up twice. Sorry.

Last edit: 01 May 2022 16:15 by Nessism.

The following user(s) said Thank You: Pattenrd

Please Log in or Create an account to join the conversation.

zed1015
Offline
User

01 May 2022 16:27 #866501 by zed1015

Replied by zed1015 on topic Overflow

Original worn float valves can be temperamental when they have been disturbed .
They usually settle once a bit of fresh fuel has passed through them and a few taps on the bowl can help them seat.

AIR CORRECTOR JETS FOR VM CARBS AND ETHANOL RESISTANT VITON CHOKE PLUNGER SEAL REPLACMENT FOR ALL CLASSIC AND MODERN MOTORCYCLE CARBURETTORS
kzrider.com/forum/23-for-sale/611992-air-corrector-jets-

Please Log in or Create an account to join the conversation.

Pattenrd
Topic Author
Offline
User

02 May 2022 03:07 #866525 by Pattenrd

Replied by Pattenrd on topic Overflow

Thanks for the quick reply I removed the carbs and checked the floats cleaned everything with carb cleaner going to hook fuel lines up and see what happens

Please Log in or Create an account to join the conversation.

Pattenrd
Topic Author
Offline
User

04 May 2022 16:34 #866628 by Pattenrd

Replied by Pattenrd on topic Overflow

Cured overflow problem after starting bike still runs pretty rich carburetors had 120 mains and 17.5 needle vm26 carbs book says 105 mains 12.5 needle kn pods and 4 into 1 should I run for octane on fuel any information would be appreciated thanks

Please Log in or Create an account to join the conversation.

TexasKZ
Offline
Platinum Member

04 May 2022 20:30 #866636 by TexasKZ

Replied by TexasKZ on topic Overflow

Have you checked the fuel level in the carbs using the clear tube method?

Unless you have aftermarket high compression pistons, the engine does not need additional octane. Use what the owners manual and service manual recommend. Using higher octane is a waste of money.

1982 KZ1000 LTD parts donor
1981 KZ1000 LTD awaiting resurrection
2000 ZRX1100 not ridden enough

www.kzrider.com/11-projects/620336-anoth...uild-thread?start=24

Please Log in or Create an account to join the conversation.

zed1015
Offline
User

04 May 2022 23:44 - 05 May 2022 00:32 #866641 by zed1015

Replied by zed1015 on topic Overflow

Mains are too big.
With the air correctors you only need to a couple of sizes or so up from stock so 110-115 max.
ALL other carbs setting should remain stock, especially pilot jets and needle position (3rd / middle groove).

AIR CORRECTOR JETS FOR VM CARBS AND ETHANOL RESISTANT VITON CHOKE PLUNGER SEAL REPLACMENT FOR ALL CLASSIC AND MODERN MOTORCYCLE CARBURETTORS
kzrider.com/forum/23-for-sale/611992-air-corrector-jets-

Last edit: 05 May 2022 00:32 by zed1015.

Please Log in or Create an account to join the conversation.

Pattenrd
Topic Author
Offline
User

05 May 2022 04:08 #866645 by Pattenrd

Replied by Pattenrd on topic Overflow

Looks like I'll be taking them off again and putting in smaller mains I have 112.5 and ordering stock needles getting to know my Kawasaki better thanks for the help again

Please Log in or Create an account to join the conversation.

zed1015
Offline
User

05 May 2022 05:19 #866647 by zed1015

Replied by zed1015 on topic Overflow

wrote:
Looks like I'll be taking them off again and putting in smaller mains I have 112.5 and ordering stock needles getting to know my Kawasaki better thanks for the help again

Stock needles ? Do you mean pilot jets ?

AIR CORRECTOR JETS FOR VM CARBS AND ETHANOL RESISTANT VITON CHOKE PLUNGER SEAL REPLACMENT FOR ALL CLASSIC AND MODERN MOTORCYCLE CARBURETTORS
kzrider.com/forum/23-for-sale/611992-air-corrector-jets-

Please Log in or Create an account to join the conversation.

Pattenrd
Topic Author
Offline
User

05 May 2022 09:19 #866653 by Pattenrd

Replied by Pattenrd on topic Overflow

Yeah
I mean pilots ordered stock ones this morning and will be taking carbs off when I get them getting pretty good at it thanks

Please Log in or Create an account to join the conversation.

Pattenrd
Topic Author
Offline
User

13 May 2022 04:32 #866995 by Pattenrd

Replied by Pattenrd on topic Overflow

Installed stockpilots and 112.5 mains bike run real good now thanks for the help

Please Log in or Create an account to join the conversation.

KZR's Bikes of the Month for 2024

Overflow

If you like KZR Please consider making a donation. Thank you.