TOPIC:

let's tank!

front mounts r trimmed, bored off and tidied up a bit

and welded... the frames welded around as well, at long last

showing off with a perfect allignment

side panels to be... soon

soon (still 1)

whoa! nice fab skills on the tank.

That tank looks amazing!

thanks heaps mates, i like, too, how it's turned out with the old tank and old kaza's frame, never done it before, i mean bracing and knee cut-outs in a steel tank. must say that a steel sheet is easier stuff for shaping than ally just because its thinner

undertray/seat/toolbox combo (lol) mounts

decided to cut off the rear section for a few reasons and behold it is very good

ust mounts welded

rear sets adapters mockup, just a mock up
feels comfortable

zorst flanges from stainless

a runner mock up, noticed it runs too close to the frame tubes, taken into concideration

1st mockup and fuckup, trial and error, mid section is 35 mm short

gunna use the faulty runner as a sample for other runners

the angles r perfect tho

twin

a brit

a jap!

no mock up

made of a 14 mm heat treatable ally, will be heat treated and powder coated soon

Nice welds, very clean!