Looking for a rear, ign; side top cylinder fin!??

Hi, I need a top rear, ignition side cylinder head fin piece!
I used to cut them off when I scrapped a head!
When I liquidated all my stuff over last 2 years. I threw out about 25 pieces into the aluminum scrap barrel.
Now, I need this one!
75 Z1B engine that I have been parting out.
Other than this fin! A real nice 6mm stud head. 1st. time it was ever dis-assembled!  Has all oem cams, bearings and caps. I was 1st to unbolt from built at factory in 1974-5
Another project on my list. This engine sat since mid-1980's. Some of you guys have bought parts over last 6 months.
Thanks.
Marty in Buffalo

Don't worry Marty I got this. I'll give you a call.

Hi Jim, seen text, sending reply!
Thanks!

Marty in Buffalo

Thank You Jim in Rochester.  Gonna save a nice Z1 6mm ex stud head. Of course matching caps, but also original camshafts and bearing shells from the factory from 74-75 Z1B engine. This engine sat since mid 1980’s?
Marty in Buffalo

Hello Jim. The head was Welded Yesterday 7-10
The piece worked great! I stopped sanding it. quit while I was ahead!  Did not want it to snap off !  
The Lucky person  who reconditions this head will be happy!  Most matching parts as it came from factory. Matching caps of course, cams, bearing shells, lifter buckets, 6mm exh studs.
A nice Media Blast or Paint job! Will look great. Luckily when I sold out! I gave up my spring compressor! Or I would have taken it apart and spent another few months playin' with it!
Of course I'm a Capitalist, and am going to try eBay to the World!  With FB marketplace @ a discount. Living in NY State ain't cheap! 
I'd like to find someone traveling to Mid-Ohio. That is coming from the East Coast, taking Interstate 90 West! I'm at exit 52 for a hand delivery.
OK, off base here, I'll post another post about that.
I'm trying to load a pic from iPhone? I always used desk top.
But here is a picture of welded head. Got a small piece of Tungsten electrode near stud circle. It's good. I think so!
Marty in Buffalo

It really is my pleasure to help people out !
Marty , keep on trucking brother.
Jim

Fantastic Job Marty!! Those camshaft bearing shells look like brand new bits to boot!