TOPIC:

For those of you that own a Z1 or other bike that has gone from a "4 into 4" exhaust to a "4 into 1" exhaust, what do you use to keep the center stand from contacting the chain? The PO of my bike made a terrible looking thing out of a piece of strap and a bolt. Can't stand to look at it. I'd appreciate any ideas and even pictures if possible.

Thanks

The center stand I bought has a triangular piece of metal that fits on the bolt and acts as a stopper.

This prevents the center stand from contacting the chain.

It looks like a small tiangle with a hole in the middle.

I'll try to get a picture, but its hard since its on the bottom of the bike.

I welded a short piece of metallic conduit to the center stand and coped it to fit against the frame tube that supports the stock mufflers.

KZCSI

Post edited by: KZCSI, at: 2006/03/03 21:32

My Kerker came with a U bolt that goes through the Center stand mounting bolt holes, with the U looping downwards. There are two rubber stops on the U for the kickstand to stop on.

Post edited by: rstnick, at: 2006/03/03 22:48

I cut off a open end wrench and bolted it to the frame, looks pretty good and works great!