Machined ZX9 cushdrive hub for project

I have a 99 ZX9 cushdrive hub that has been machined back to the bearing and the sprocket land has been machined down 5mm to move the sprocket inboard. This was done to cram a ZX9 5.5" wheel into a GPz1100 swingarm (or other "narrow" swingarm) but I ended up going with another swingarm and ZX6 cushdrive. $40 plus postage if anybody can use it.

Post edited by: Fossil, at: 2007/05/29 20:27

can you email me pics?? I have a zx9 wheel and hub that i wanted to fit to my calfab swing arm but they were too wide so i started to build a chromemolly swing arm but i would like to use the calfab aluminum.

wendy
wendywhip@yahoo.com