Who's got a KZ650 frame without a motor in it right there?

Measure something for me please.

I need the measurements of the carrier for the motor.

Interior measurments only.

Height from bottom to top tubes.

Length from front to back.

Width between the bottom tubes.

And a diaganol measurement from the front upper to the bottom lower area of the carrier.

Thanks

*Possibly bidding on something that ends in a few hours, so if someone has the means and can do it asap I will be greatly appreciative!!

Nevermind, I went home during break and measured mine. It'll fit. :evil:

caffcruiser wrote:

Nevermind, I went home during break and measured mine. It'll fit. :evil:

The GPz750 motor on eBay?
If that's the case then I could have told you that

If not then fess up, what kinda strange thing you gonna do now?

Nope, not the GPz750 motor with 3300 miles on it, I just checked and it has two days left

So what is it??????
The suspense is killing me!!

Post edited by: steell, at: 2007/01/02 18:50

steell wrote:

caffcruiser wrote:

Nevermind, I went home during break and measured mine. It'll fit. :evil:

The GPz750 motor on eBay?
If that's the case then I could have told you that

If not then fess up, what kinda strange thing you gonna do now?

Nope, not the GPz750 motor with 3300 miles on it, I just checked and it has two days left

So what is it??????
The suspense is killing me!! <br><br>Post edited by: steell, at: 2007/01/02 18:50

I can't disclose the exact mill, but I'll give you this: You're thinking about 20 years too old.:laugh:

I might be listing some KZ big bore kit/GPZ parts up for sale now though...

Post edited by: caffcruiser, at: 2007/01/02 20:07

caffcruiser wrote:

I might be listing some KZ big bore kit/GPZ parts up for sale now though...

I call dibs until I see what you have

Hmmm, R1, ZRX, Zx10, Zx12??

Post edited by: steell, at: 2007/01/02 20:20

steell wrote:

caffcruiser wrote:

I might be listing some KZ big bore kit/GPZ parts up for sale now though...<br><br>Post edited by: caffcruiser, at: 2007/01/02 20:07

I call dibs until I see what you have <br><br>Post edited by: steell, at: 2007/01/02 20:17

What I have for sale?

caffcruiser wrote:

What I have for sale?

Uh huh, I have a J motor in a GPz750 project now

Nevermind. GuitarGeek talked some sense into me (again. haha)

Post edited by: caffcruiser, at: 2007/01/02 21:16

Bummer for me

Want this thread deleted?

I want to know what he was gonna stuff into a 650 frame...I bet a ZRX1200 motor would look some nice in one...(might be a future project for me:whistle: :evil: )
Scott