Kz1000 single seat rail...help!

well i got power to my coils and spark,,,whoohoo! now just to tidy up the harness,,,and front rims and im driven it! lol

ok well i got it to run kinda lol can anyone tell me what the order is when u r at the back of the moter ?the outside cylinders the cylinder obove the magnetic pick ups witch one is that one,,does one coil run the too cylinders that r next to oneanother or does it skip one and go to the next? any help would be awsome,,thanks

Looking at it from the carburettor side (or as if you were sitting on the bike),
the left cylinder is 1, and the right cylinder is 4. (The one above the
ignition is 4.)

One coil fires 1 and 4, and the other coil fires 2 and 3. If everything was
original, the rear pickup with the black/blue wires controls the spark coil
with the black wire and that goes to cylinders 1 and 4. The front pickup with
the yellow/red wires controls the spark coil with the green wire and that goes
to cylinders 2 and 3. (I call them front and rear pickups because one is
near the front of the motor and the other is near the rear of the motor, but
some call the black/blue pickup the left and the red/yellow the right
pickup, as you look at them.)

If it won't run at all, make sure the ignition rotor points toward the black/blue
pickup when pistons 1 and 4 are near top dead center.

Post edited by: loudhvx, at: 2008/02/17 02:25

thanks alot all u peeps are cool as hell,,,now im of to my garage lol

well i got it to run pretty good ,,some carb work is needed but i got a grin on my face! thanks

Excellent! More photos are always welcome when you get a chance! This might be a good one for the "projects" forum.