900/1000 starter parts

Hey guys, I’m looking for a couple of parts for a 900/early kz1000. Need the starter idler gear bearing and the tapered washer behind the idler. Anyone have anything they’d part with. Needed for my drag bike asap. 

I'm sure i have a few laying around. I assume you're referring to the "clutch" not the idler? Is it a 15pin crankshaft? A handful of parts also needed as you know for a working starter, if that's what you're aiming for. 

I did find a nos bearing but still need the washer between the gear and the clutch, plus the tapered washer behind the gear. I have new old stock clutch assembly as well. 

Crank is the early small taper type.  

Perfect! Let me dig some out and get you some pics.

Are these what You seek? Beveled 92026-091 and plain brass 92026-092. Because i know you know what you're doing but might measure the outside "lip" of the starter gear where the beveled washer goes just to verify, should be about 35mm. Other ones shown are for the 79-up and their gear lip is around 40mm, just for reference. Is Your clutch housing in great shape? I couldn't count the number of times i've seen persons purchase those "roller kits" thinking that will fix their starting issue. Rarely the case, it's the machining of the ramp that the BIG rollers tighten-up in and grab the gear that has worn-down so you lose the "pinch" needed.  

Those are it. Need the 35.5 beveled washer and the damper as well. The coppers I think I have the right one. 

The clutch is in good shape but I ordered a nos one from Kawasaki. I’ll have a spare for at the track plus a rebuild kit. 

Willing to part with the pieces I need? 

I would but i'd just have to check how many more of the bits i have, just grabbed a sampling from one tupperware container. I've got a couple Z1's and a Z2 i'm refurbishing the engines on and don't want to have to source parts at premium prices if i don't have to. Seems they are asking around 40.00 for the weird beveled replacement washer on ebay! As far as the damper, you probably won't know what "thickness XXX" you'll need till you use a sample for installation. Hopefully your thrust pin in cases hasn't been hammered out of place, you'll never find the correct damper in that case.   
 

Just an update: I have all the parts covered except the big gear (small inside dia.) 

would you part with the copper coloured one?