7X andrews cams

I Have a set of 7X andrews cams, would anyone be interested in trading for something smaller. Something that would be a little more street friendly. They are out of a kz900.

Post edited by: jasbarsydvic, at: 2005/10/30 11:09

Post edited by: jasbarsydvic, at: 2005/10/30 18:49

what are the specs on 7X cams? I might have something to trade.....

266 duration @.485" lift

ill trade you my stock cams for them.

I'll buy you a new set and trade you for your jack stands under the truck in your pic

I am looking for something, that is bigger than stock, because the 900 isn't a 900 anymore. But i still want to be able to sit at a stop light and not load up. With these cams and a 1045 big bore kit, i had 161hp and 207 ft lbs torque at rear wheel this summer on the dyno.
And yes they are very nice jack stands, but not for sale.:evil:

Post edited by: jasbarsydvic, at: 2005/11/01 18:18

Would you be interested in selling those cams? If so how much $ ?:evil: :evil: :evil: :evil:

what size valves do you have in your cylinder head?
Shim under buckets?
-Duck

yes they are for sale. I have 6 people interested in them. I am asking 125 obo. I have 40mm intake and 33mm exhaust. Yes i do have under bucket shim

161 rwhp,207ft of torque boy those number's are impressive please give sum details of this engine.

well i am still taking it apart. so far i have over size valves in a J model head,ported and polished.the head must of been milled down alot. high compression 1045 kit. It had 220 psi of compression. Had to run race fuel in it! It was a drag bike when i bought it. That is all that i have found so far. The motor is really lose, like a race motor should be, but was'nt very good for the street. The gearing is 530, 16 front 52 rear.