What kind of exhaust is this?

austin3119 wrote:

I'm near I-51 and Cactus.

Only in Arizona

Tou can drill a small hole on the other side of the deny and use a small punch to tap out the dent and then weld up the hole and it shouldn't show too bad.

Mark

Yet more about exhaust header pipe dent removal, including the following excerpts:

timebomb33 wrote:

find a ball bearing that is just abit smaller than the inside diameter braze a chunk of wire rope to it and then pull it down to the crushed part of the pipe then heat the pipe up until it is red hot at the crushed part then pull the bearing thru it repeat on the next headers it will work very well keep the pipe red hot while your doing it.

timebomb33 wrote:

try the ball bearing trick it works awesome i've never seen anything even come close.

Click here > KZr thread

Am still gun-shy about heating a plugged pipe to cherry-red. Seems too much like a pipe-bomb that might explode by bursting out somewhere else besides one of the plugged ends. :ohmy:
Just call me Chicken. :laugh:

Good Fortune!

MAC was talking about producing them.