bore job????????????

had my cylindeer block done by way of an in town friend who i knew knew his shit...cost me $375...but...2 of my sleeves were loose...took them out and blasted them and put back in with sleeve locker...also milled both decks perfect..bore job looked perfect to me..could see the 60 degree angle very well..and chamfered the ends for ring installation..bike runs better than ever..just wondering what everbody else was paying??

$50-$60 bucks a hole seems to be average for boring,but he did a lot of extra work for ya.i would rather pay somebody who knows what hes doing what he wants rather than worrying about the work the cheap guy did;)

Point very well taken...and understood...

$95.00 with a piston purchase. $160 with customer supplied pistons.

KZ1000s do have loose sleeves and require special precautions.

Jay