KZ700

I just went with mac. I would like to put a yoshi pipe on but that will have to wait

What do you guys think of powdercoating Valve Cover to match engine side covers?


New Powdercoated Stator Cover to Match Wheels



License Plate...LOL

BEEP BEEP!!!!

Marklorenzo wrote: What do you guys think of powdercoating Valve Cover to match engine side covers?


New Powdercoated Stator Cover to Match Wheels

License Plate...LOL

Put the rear wheel back on today. Having a bit of a concern. Everything was put back exactly following manual, but my brake bracket and rotor seem odd. Looking from the rear, the rotor is very close to the left inside the brake bracket. I spun the wheel and rolled bike down driveway and back and did not have any weird noises, but it seems too close for comfort..posted something in Chassis section so hopefully someone has some insight. During any project I normally take tons of pictures as a "Just in case" but can not remember if it was like this or not. But here is a picture of bike as it sits now. Have to hit up the hardware store tomorrow since I lost the two bolts that hold my license plate bracket on.

Looks good! I have too get moving with mine. Been lazy.

Its looking better and better day by day.

Figured out the problem with my rotor. Act of stupidy. Had it on backwards LOL :sick:



However, on to the next problem. Running well until idle kicks down and it starves of fuel it seems. IDK!

Ordered a few new things. New plug wires, seat cover and air box.

Front forks back off. Leakage...... :sick:




New ACEWELL Gauge

dime city is only a few miles from my house

I have had very good luck with them. I am part of a firefighters motorcycle club and every year we host a ride for the Hoosier Burn Camp in Indiana. Dime City sends us goods to raffle off. Great company and great customer service.