KZR's Bikes of the Month for 2024

hey ltd guys

More
04 Mar 2006 19:11 #28281 by hydrolazer
hey ltd guys was created by hydrolazer
whats the best way to lube the chain since we dont have center stands on our bikes?,,im an army of me and any easy way you know of will greatly be appreciated,,,tia......its a 79 ltd 1000

\'79 kaw 1000 ltd

Please Log in or Create an account to join the conversation.

More
04 Mar 2006 20:09 #28298 by ejshotgun
Replied by ejshotgun on topic hey ltd guys
I use a good spray lube. I use a cloth to keep over spray off of my tire and spray part of the chain(on the lower end) move the Bike and do the next group until the whole chain is lubed.

Please Log in or Create an account to join the conversation.

More
06 Mar 2006 12:09 #28710 by Rickman
Replied by Rickman on topic hey ltd guys
What is this 'chain' of which you speak? :laugh: Oh sorry, I thought you were talking to me! :silly:

1983 KZ1100-L1 "LTD Shaft"
Wiseco 10.5:1 1171 piston kit, bored by APE
Dyna 2000, Dyna S, Dyna grey coils, WG coil power mod, CB900 starter

Please Log in or Create an account to join the conversation.

More
06 Mar 2006 16:45 #28785 by dnyce
Replied by dnyce on topic hey ltd guys
yep, spray and roll

Please Log in or Create an account to join the conversation.

More
06 Mar 2006 18:44 #28848 by roy-b-boy-b
Replied by roy-b-boy-b on topic hey ltd guys
You can put a center stand on a LTD and remove it after you service the bike. Roy

1979 LTD Street Fighter.1977 KZ1000

Please Log in or Create an account to join the conversation.

  • ran429
  • Offline
  • User
  • Master of FREE rides!
More
06 Mar 2006 18:49 #28854 by ran429
Replied by ran429 on topic hey ltd guys
make or purchase one of these and call it good.
www.peglift.com/

Post edited by: ran429, at: 2006/03/06 21:49

Please Log in or Create an account to join the conversation.

More
07 Mar 2006 09:28 #29001 by ltdrider
Replied by ltdrider on topic hey ltd guys
That peglift looks like it'll do the job, but $239!:ohmy:
I went to Autozone, and bought a $25 floor jack. I just slide it under the engine (from the right side), and pump it about 3 times. Lifts the rear wheel so I can spin it. It helps to put the side stand on a 2x4 block before you lift it, that way the bike doesn't lean too much when you use the jack.

'76 KZ900 LTD (Blaze)
'96 Voyager XII (Dark Star)
'79 KZ650 Cafe Project (Dirty Kurt)
Greensboro, NC

Please Log in or Create an account to join the conversation.

More
07 Mar 2006 10:33 #29024 by Mcdroid
Replied by Mcdroid on topic hey ltd guys
Silly as it sounds, get on eBay and search under swingarm stand. There are plenty and reasonably priced. Easy to use and your bike is safely supported.

Michael
Victoria, Texas

1982 GPz750
1977 KZ1000A
1978 KZ1000A
1982 GPz1100
1975 Z2A

Please Log in or Create an account to join the conversation.

Powered by Kunena Forum

If you like KZR Please consider making a donation. Thank you.

KZRider is free, but not without cost.

Please consider chipping in a few bucks to help cover the cost of running the KZR servers.