KZR's Bikes of the Month for 2024

How to test IC Igniter

More
29 Jul 2012 12:50 #539377 by RaD
How to test IC Igniter was created by RaD
Hi everyone
I got kawasaki KZ650 H3 83'
How to test IC IGNITER ? I can find nothing about it in Clymer's book.

Thanks a lot girls and boys
Best Regards
RaD

Please Log in or Create an account to join the conversation.

More
29 Jul 2012 14:28 #539390 by MFolks
Replied by MFolks on topic How to test IC Igniter
See if it's the pickup coils first, they can get intermittent when hot:

Ohm Checking Pickup(Pulsing) Coils

The pickup(Pulsing) coils on the Kawasaki’s with the factory supplied electronic ignition can sometimes fail or become intermittent due to heat and vibration.

1.Trace back from where the pick up coils are mounted,(BEHIND A RIGHT SIDE, CD SIZED COVER) locate and disconnect a small 4 pin connector. Using a multi-meter set on OHMS and range of 2K, check between the BLUE and BLACK wires(#1 and #4 sparkplug wires) for between 360- 540 OHMS.

2.For #2 and #3 sparkplugs the wire colors will be YELLOW and RED, again 360-540 OHMS. The 550’s,650’s & 750’s may be backwards to the Z1’s,Kz900’s,Kz1000’s & Kz1100’s.

3.If the pickup coils are suspect of failing due to heat, they can be stressed using a hair dryer without the need of the engine running.

4.A replacement set of pickup coils might be obtained from a dealer who serviced the police Kawasaki’s.

5. If replacement pickup coils are not available, your next choice would be to order a Dyna “S” electronic ignition system from www.z1enterprises.com It replaces the IC igniter with a smaller module located where the mechanical ignition advancer was mounted.

6. Checking with Kawasaki.com website has determined that the Pick up(pulsing) coils are available . The pulsing coil # is 59026-1133 and replaces the older # 1002, 1012 which were used from the MKII motors until the 2005 P24.

7.Check the small 4 pin connector that the pickup coils connect to for corrosion/loose pins too.

1982 GPZ1100 B2
General Dynamics/Convair 1983-1993
GLCM BGM-109 Tomahawk, AGM-129A Advanced Cruise Missile (ACM)

Please Log in or Create an account to join the conversation.

More
29 Jul 2012 15:06 #539397 by Patton
Replied by Patton on topic How to test IC Igniter
If not already done, would assure the black-yellow wire from the igniter is providing a good ground.
And that the connectors and bullets associated with the black-yellow wire are clean and snug fitting.

Would also assure integrity of ground connection where the negative battery cable attaches to rear of the engine.

Good Fortune! :)

1973 Z1
KZ900 LTD

Please Log in or Create an account to join the conversation.

More
29 Jul 2012 16:38 - 29 Jul 2012 16:39 #539406 by Old Man Rock
Replied by Old Man Rock on topic How to test IC Igniter
Here you go....

BTW... This OEM Manual can be found here---->>>> FREE! KZ650 OEM Manual



1976 KZ900-A4
MTC 1075cc.
Camshafts: Kawi GPZ-1100 .375 lift
Head: P&P via Larry Cavanaugh
ZX636 suspension
MIKUNI, RS-34'S...
Kerker 4-1, 1.5" comp baffle.
Dyna-S E.I.
Earls 10 row Oil Cooler
Acewell 2802 Series Speedo/Tach
Innovate LC1 Wideband 02 AFR meter

Phoenix, Az
Attachments:
Last edit: 29 Jul 2012 16:39 by Old Man Rock.

Please Log in or Create an account to join the conversation.

More
15 Aug 2012 09:22 #542739 by keithnra
Replied by keithnra on topic How to test IC Igniter
is this the same for a kz1000

Please Log in or Create an account to join the conversation.

  • Motor Head
  • Offline
  • User
  • FIX UP YOUR BIKE RIGHT AND CHEAP
More
15 Aug 2012 09:53 #542743 by Motor Head
Replied by Motor Head on topic How to test IC Igniter
What year KZ1000? 81-83 service manual in pdf in my signature will have all of the tests.

1982 KZ1000LTD K2 Vance & Hines 4-1 ACCEL COILS Added Vetter fairing & Bags. FOX Racing rear Shocks, Braced Swing-arm, Fork Brace, Progressive Fork Springs RT Gold Emulators, APE Valve Springs, 1166 Big Bore kit, RS34's, GPZ cams.
1980 KZ550LTD C1 Stock SOLD Miss it
1979 MAZDA RX7 in the works, 13B...

Please Log in or Create an account to join the conversation.

More
15 Aug 2012 10:43 - 22 Jan 2013 21:19 #542759 by martin_csr
Last edit: 22 Jan 2013 21:19 by martin_csr.

Please Log in or Create an account to join the conversation.

  • Street Fighter LTD
  • Offline
  • Moderator
  • TURBO, Its Better to be Blown than Injected
More
09 Dec 2023 09:17 #892484 by Street Fighter LTD
Replied by Street Fighter LTD on topic How to test IC Igniter
Lumbee 
Your post was all code   Deleted  as before on the other thread 
Read about posting pictures  and attachments and try again
Also this thread is over 10 years old 
You may not get a reply 
Dave


Original owner 78 1000 LTD
Mr Turbo Race Kit, MTC 1075 Turbo pistons by PitStop Performance , Falicon Ultra Lite Super Crank, APE everything. Les Holt @ PDM's Billet Goodies . Frame by Chuck Kurzawa @ Logghe Chassis . Deep sump 5qt oil pan. RIP Bill Hahn

Please Log in or Create an account to join the conversation.

Powered by Kunena Forum

If you like KZR Please consider making a donation. Thank you.

KZRider is free, but not without cost.

Please consider chipping in a few bucks to help cover the cost of running the KZR servers.