KZR's Bikes of the Month for 2024

Help!

More
07 May 2006 13:58 #45710 by buddyro
Help! was created by buddyro
Trying very hard and spending too much time trying to figure this out. Please help, I'll try anything.

No spark at the plugs. Have power at the coils. ~3ohms accross primary and ~20ohms across secodary windings (though I do not get a constant reading across secondary I think b/c I cannot get good contact w/probes). Have good ground connections, no loose connectors. All electrical components work (except rear blinkers).

What can I do next? Is my Dyna III bad?

Please Log in or Create an account to join the conversation.

More
07 May 2006 16:44 #45738 by Sandy
Replied by Sandy on topic Help!
Kill-Switch on??:P
Seriously though...a lot of Guys HAVE done it...
1977 KZ1000 A-1

Please Log in or Create an account to join the conversation.

More
07 May 2006 16:56 #45740 by buddyro
Replied by buddyro on topic Help!
Kill switch definitely not on. My starter will not work when off.

Thankyou much for replying. I'm dyin here on such a gorgeous, almost over day.

Please Log in or Create an account to join the conversation.

More
08 May 2006 18:48 #46021 by buddyro
Replied by buddyro on topic Help!
Got it!! It was that sneaky red wire from the dyna III. It broke off from the splice into the coil circuit. Finally on the road again!

Please Log in or Create an account to join the conversation.

Powered by Kunena Forum

If you like KZR Please consider making a donation. Thank you.

KZRider is free, but not without cost.

Please consider chipping in a few bucks to help cover the cost of running the KZR servers.