Wiring Harness ?

I am beginning to realize that I am uncertain about where the wiring harness goes back onto the bike, I think the beer took advantage of me when I was taking it apart:whistle: Does anyone have pictures or the general idea where I need to feed this back through and which sides go where? Any help will be awesome!

Welcome to the club!!!

I am in the same situation, only mine was mostly apart when I got the bike. I have been looking at pictues online and in my manuals, but I haven't found what I need either. I am going to watch this post with you.

Mark

I'm glad that I'm not the only one then;) I just am baffled at where this stuff goes, if other people have true picture of where this thing goes, you'll be helping out two KZer's.:woohoo:

Yeah, blame the beer!:whistle: I didn't pull off the entire harness, but got screwed up just with the gob of electronics under the side covers. I took my time and tried to let the wires show me how they wanted to go, if you know what I mean... The critical things would be that no wires would be in a position to be pulled, strained, pinched or otherwise injured. My 750 isnt here right now so I'm not much help, but the best bet might be a phone call with someone who could walk you right through the bike, stem to stern so to speak; or a video email sweeping up and down the harness. How close can you get your computer to the bike?? Good Luck!

Dont know if they the same or not, but I can shoot pics of mine (77 KZ1000A) and post. Harnes never been out (far as I know), and the bodywork is off anyways....
Like I said....dunno if that'll help ya:unsure:
Send me a PM or just post when ya can.....

Post edited by: indykaw77, at: 2006/03/16 15:51

Lay the harness on top of the bike along the main tube and all the way back to the tail, after you have everything else electrical mounted. Then you can just match up plugs and take the parts off as needed to run the wiring. You already know the big thick part of the harness is tied to the main tube, so start there

As far as the 80 KZ750T goes, I can help out more with that one, but it will probably be next week before I can take any pics.

I got the part which it goes too, it is the feeding/tieing it down parts unsure of. I have the harness run through the left side to the light and it going into the fram between the coils, but I dont remember where I have feed it back towards the airbox/to where it friggin goes:blink:

Probably not much help here, but mine is running along the top tube toward the airbox. Then it drops down to below the battery where it gets the reg/rec. I hope this helps but mine has been out and I was confused about how it ran also, and it still needs work.

Do you have a diagram for the bike? Check the filebase or PM me I think I have one on my computer.

Post edited by: danoz7five0, at: 2006/03/17 23:45