Mikuni Flatslides Bell crank wheel

Wookie58 wrote:

DFIGPZ wrote:

joe
 if you want to ship to Maryland I have had many sets of Mikuni Flatslides apart shoot me a PM if you do not want to tackle yourself

Barry

PM doesn't work but I can put you in touch by email if you are both in agreement

I am ok with it
 

Email works for me. Thanks.

rivman15 wrote:

Email works for me. Thanks.

Hi Joe - I sent it to your frontiernet email 31/3/2023, I guess that is old news. Have forwarded to your gmail

rivman15 wrote:

Email works for me. Thanks.
if you decide to email me put "MIKUNI Flatslide repair " in subject line

Barry
 

I did not realize my very old email was still in there, Holy cow I have been on here along time. New email has been updated. Thank you.



 

I am going to take a stab at this. Can you remove just half the carbs off the bar to get to the bell crank or does it have to be completely dis assembled? 

Do you have to remove everything off the throttle shaft to split the carbs?

In my opinion you only have only remove carb# 1+2 to slide out the cank wheel to the LH site of the throttle shaft.

Taking a quick break. There must be another doll pin I havent seen. I was trying to remove carb #4 first and it appears to be still locked on(loose but not coming off)  Throttle bar is still attached I can see it would be easy to replace as soon as I can get that throttle shaft off.

There has be to something else holding the throttle shaft on. Not sliding out.

Do as Scirocco says. Remove 1&2. Taking off 3&4 gets you into the return spring and cable bracket. 

I do never understand the people asking here for help and than do the opposit as suggested
What a waste of life time sometimes.....