'78 KZ1000 makeover

You're probably aware of it, but use some anti-seize when mixing metal types (SS into Al).

I wish the factory would have remembered that. It would have saved me $40 in EDM services

Here is my newly anodized outboard bearing support. I left the bearing carrier clean. I thought polishing it and using stainless button head cap screws would look cool

And of course my triple clamps :woohoo:

Ooooooh, I like the stainless hardware against the black anodize

looks awesome adam!!!! i forgot, what offset are you running?

porchev914 wrote:

Here is my newly anodized outboard bearing support. I left the bearing carrier clean. I thought polishing it and using stainless button head cap screws would look cool

Very Nice .
I have 1 as well. Have u tried it for fit yet?
The black trees look awesome too.

kz1k wrote:

looks awesome adam!!!! i forgot, what offset are you running?

Offset for what? I have a few offsets on my bike :laugh:

Looking good!

mark1122 wrote:

Very Nice .
I have 1 as well. Have u tried it for fit yet?
The black trees look awesome too.

I have tried it for fit Mark, and I need to modify it a bit before it will fit. I have some frame clearance issues with the plate. The endless cycle of mods because of other mods

porchev914 wrote:

kz1k wrote:

looks awesome adam!!!! i forgot, what offset are you running?

Offset for what? I have a few offsets on my bike :laugh:

the sprocket?:blink:

i had some frame clearance issues as well. i am going to mount a bracket to the foot peg bolts. then i will bolt the baring plate to the bracket. this way i don't have to weld a bracket to the frame that will prevent me from remounting the stock sprocket cover.