TOPIC:

"You shouldn't have to do anything to the motor unless you want to put in a Wiseco 810 kit, maybe port the head. Get a nice pipe, ditch the airbox for some pods, rejet and you're good."

i wanna get the 810 kit put in, the pipe,pods the whole works!.... its going to be a mean lookin bike when its done.!

Here she is with just the swingarm sitting there just to see what its going to look like.

Here she is... still havent figured out what route im going to take to mount this sucker on there.

.

.

okay, let's get to work shall we?

I need some measurements, so get out your dial caliper.

1) Width of swingarm at pivot. (You could pull the sleeve and just measure that, as thats what really counts.)

2) Width of frame interior pivot area.

3) I.D. of swingarm pivot sleeve.

4) I.D. of frame pivot holes.

I assume you will be going single shock? If so, there's a bunch more to do, but this is the first step.

Get me those measurements and I'll tell you the easiest way to go about mounting it. I have one of those swingarms here someplace I think but I'm getting ready to move, so I haven't a clue where it is! lol

ok as of right now i only have a few of the measurments the width of swingarm sleeve is 28.00mm,
I.D of sleeve is 20.00mm, the new zx6r pivit bolt is 19.94mm and the kz bolt is 15.95mm

tomorrow i will get the other measurments for you
Code

ps - do you have msn messanger? add - This email address is being protected from spambots. You need JavaScript enabled to view it.

Code2 wrote:

ok as of right now i only have a few of the measurments the width of swingarm sleeve is 28.00mm,
I.D of sleeve is 20.00mm, the new zx6r pivit bolt is 19.94mm and the kz bolt is 15.95mm

tomorrow i will get the other measurments for you
Code

ps - do you have msn messanger? add - This email address is being protected from spambots. You need JavaScript enabled to view it.

Ninja sleeve is 20mmID, right? K. Good. We got that.

By #1 I meant width of the sleeve, as in length. The OD of that sleeve (28mm) is irrelevant. Lemme see if I can find my arm to measure some of the against.

Also, how far do you want to mod the bike? Are you planning on ever taking it back to stock again? If so, there's certain ways we need to go about this. lol

If not, it's much easier and faster. aha

nope, as soon as it is coverted thats how she stays!

YES I found a thread on this.
What ever happend to this project?
?

actually i just started to get the thing on there...lol took a big break... had to save some loot for the project... ,

anyways i STILL dont no how im going to go about doing this project, iv got all the measurments here i just need somone to give me some direction, ground work, anything i can follow... parts list im going to need to complete the job... ANYTHING!..

heres a mock up pic of the bike with tire and swingarm.