Can I bore These Sleeves??

wireman wrote:

shhhhhhhhhhh! everybody be verrry qwiet im huntin the olll swugggggs hehehe!:whistle:<br><br>Post edited by: wireman, at: 2006/03/02 10:14

:huh: :huh: :huh: :huh:

I Think you are OK. If the bottom of the sleeve was larger than the part in the block, it would have been fun watching your old engine builder get them in the block.

Jay

79MKII:it was my best inpersanation of elmer fudd hunting pistons i could come up with!:whistle:anybody saying it wouldnt work would have screwed up my plans:whistle:

Post edited by: wireman, at: 2006/03/02 21:55

OK, gotcha! I knew it was Elmer Fudd, but didn't pick up on the "slugs" part. I guess I'm a little slow:S You wascawy wabbit:P

Post edited by: 79MKII, at: 2006/03/02 22:33

APE Jay wrote:

I Think you are OK. If the bottom of the sleeve was larger than the part in the block, it would have been fun watching your old engine builder get them in the block.

Jay

Well Duh!!:blush: I forgot about the lip on the top. I guess those only go in one way!! Now I can rest assured that the sleeves are at least 3.240 OD inside the cylinders. Thanks again for all of the help. I love this site!!

and we love you too!:whistle: and your old pistons!:woohoo: