TOPIC:

Primary shaft 16 Oct 2014 16:35 #650851

koloj Topic Author Offline User Posts: 223 Thank you received: 5	Well got my new starter clutch in and I wanna install it but I'm wondering is their suppose to be washer between outside bearings and primary shaft 1980kz750 h1
	Please Log in or Create an account to join the conversation.

Primary shaft 16 Oct 2014 17:17 #650858

JR Offline Sustaining Member Posts: 2911 Thank you received: 429	I have never replaced starter clutch Parts diagram might help. KZ750 E1 1980 1980 kz750E1, Delkevic exhaust Attachments:
	Please Log in or Create an account to join the conversation.

Primary shaft 16 Oct 2014 17:27 #650863

JR Offline Sustaining Member Posts: 2911 Thank you received: 429	1980 KZ750 h1 1980 kz750E1, Delkevic exhaust Attachments:
	Please Log in or Create an account to join the conversation.

Re:Primary shaft 17 Oct 2014 07:31 #650927

koloj
Topic Author
Offline
User
Posts: 223
Thank you received: 5

FYI it don't use a washer on the 27mm bolt side if u ever change the shaft or replace the starter clutch just make sure the bearings are in all the way the clutch gear side has a bearing stop with in the hole but on the 27mm side it don't so u can tap the Bearing pretty close to being flush with the primary shaft.... Also.... If u ever install one put the clutch gear on first would make bit easier also the bearing plate behind it put it in place kinda tight squeeze back their thanks

Please Log in or Create an account to join the conversation.

Primary shaft 17 Jan 2015 11:58 #658904

Colt_1049 Offline User Posts: 1 Thank you received: 0	Where did you order your starter clutch from?
	Please Log in or Create an account to join the conversation.

Page:
1

Forum

Technical Forums

Engine

Primary shaft